Genuine OEM Husqvarna Soff-Cut G2000 parts for your walk-behind, early-entry concrete saws. Keep your G2000 cutting clean joints with the right blade-block hardware, belts, wheels, sensors, and controls. The G2000 is an early-entry walk-behind concrete saw used to cut control joints in freshly placed (“green zone”) concrete, helping prevent random cracking on slabs and pavements.
Shop Husqvarna Soff-Cut G2000 Parts
- Blade block & cover kits, diverters, lexan shields
- Guide wheels, axles, front/rear rod clamps
- Drive & blade shafts, bearings, bushings, retaining rings
- V-belts (3VX425), motor sheaves & sprockets
- Actuators: blade, pump, guide, speed control
- Electrical & sensors: proximity/FPM sensors, hour meter, voltmeter, rectifier, LED light kit
- Cables & controls: choke cable, handle grips, knob kits
Popular G2000 Parts (Quick Picks)
- P3647 Hood Knob Kit (505886601)
- P21011 Guide Wheel Kit (505877701)
- M28525 V-Belt 3VX425 – Set of 2 (505482203)
- K25001 Blade Block Cover Kit (505857601)
- E295006 Speed Control Actuator (505845101)
- E39520 Foot-Per-Minute Counter (505847301)
- P21593 Drive Shaft Kit (505880501)
- M28516 60-Tooth Sprocket (505867101)
Fitment & Verification
Confirm your model as Soff-Cut G2000. If you’re unsure about serial breaks or part supersessions, share your model/serial and we’ll verify before you buy.
Email us at [email protected] or call us at +1 (202) 630-1027 and we’ll help you find the correct parts.
Browse other Soff-Cut models
- Soff-Cut 150 parts
- Soff-Cut 150D parts
- Soff-Cut 150E parts
- Soff-Cut 50 parts
- Soff-Cut 2000 parts
- Soff-Cut 2500 parts
- Soff-Cut 4000 parts
- Soff-Cut 4200 parts
- Soff-Cut 5000 parts
- All models hub: Husqvarna Soff-Cut Concrete Saw Parts
Husqvarna Soff-Cut G2000 FAQ
What is the Husqvarna Soff-Cut G2000 used for?
Early-entry cutting of control joints in freshly placed (“green zone”) concrete to help prevent random cracking.
When should I make the cuts?
As soon as the slab can support the saw and operator without marking the surface—timing depends on mix, weather, and finishing conditions.
Does the G2000 cut dry or wet?
It’s a dry-cutting early-entry system. Use appropriate dust control per local rules and jobsite practices.
Do I need the anti-ravel skid plate?
Yes. Soft-Cut blades use a matching skid plate to minimize chipping/spalling—replace the skid plate when you change blades.
Which blade series/color should I use?
Choose blade series based on aggregate hardness and sand abrasiveness; Soff-Cut blades are color-coded for this. If you’re unsure, we’ll match your slab conditions.
How deep should control joints be?
A common guideline is at least 1/8 of slab thickness and at least 1 inch deep, unless your project specs say otherwise.
What Arbor/blade style does the G2000 use?
Soft-Cut early-entry blades with the triangular safety Arbor and the matching skid plate.